Cable plan workspace > Editor
It is possible to achieve special cabling by manually drawing module cables.
-> How to proceed:
Go to the cable plan and click in the "Cabling" toolbar on the 
button, to draw a module cable.
The mouse pointer will also turn into a pencil symbol.
(You can also draw by simply holding down the "
Shift" key while drawing.)
Using this pencil, you can manually draw a string of the module cableon the PV module.
- With the mouse go to the desired starting module,
- hold down the left mouse button and
- drag the mouse, holding down the left mouse key, to the next PV module.
As soon as the "pencil" mouse pointer goes over the small square in the middle of the module this PV module is connected.
To skip a module, go around this square with the mouse.
Cable all the modules of this string in this way otherwise the following message will appear: 
"The cable is incomplete!"
The cable will be shown in gray and will not be saved or included in further calculations as long as it is not complete.
An incomplete cable can only be further drawn on the minus pole or also "unwound in reverse" and partly redrawn.
If you click on another point on the string, the existing cable will be completely redrawn and - if already present - separated from the rest of the cable plan.
! Note: if strings whose connection cable has been manually drawn are further cabled with other nodes, either automatically or manually, the connection cable will be retained and will not be automatically redrawn! If desired, it must be deleted beforehand.